Technical manual summary
Tech sheet W10806847B explains diagnostic-mode entry, stored fault codes and component checks for technicians. Its F1E1 entry identifies a Cycle Control Unit (CCU) problem and directs attention to connections and the CCU power test. The sheet should be matched to the appliance before following its control-button sequence.
Temperature sensing has separate entries for different faults: F3E1 describes an open exhaust thermistor and F3E2 a shorted exhaust thermistor. The component-test section also distinguishes inlet from outlet sensing. The moisture-sensor and motor-circuit tests give further diagnostic routes when the symptom is poor drying or a drum that will not run.
The sheet also covers door-switch checks, airflow and no-heat complaints. Its heat-system tests separate electric and gas equipment, including gas-only component procedures. Those gas sections are not instructions for an electric WED model. Electrical measurements, internal access and part replacement belong to a technician using the correct wiring and model information.
The document associated with this page is W10806847B. Exact WED85HEFC1 revision applicability remains under review. Match its document number, control layout and wiring to the appliance’s own tech sheet before using procedures.
Document references
W10806847B is a technical service document, separate from owner operating instructions. It is also used in the WED85HEFW2 and WED92HEFW0 references; shared documentation alone does not establish exact model compatibility.
For owner instructions, use Whirlpool’s manual lookup with the complete model from the appliance label.