Technical manual summary
The W10806847B tech sheet brings diagnostic entry, component activation and sensor feedback into one service reference. It explains how technicians retrieve stored faults and use the diagnostic test to observe systems such as the motor, heater, door switch and moisture sensing. Applicability must be checked against the appliance before following its control-button sequence.
In this document, F1E1 means a Cycle Control Unit (CCU) problem and points to connection checks and the CCU power test. F3E1 describes an open exhaust thermistor; F3E2 separately describes a shorted exhaust thermistor. Keeping those two entries separate matters when using the code table.
The heat-system section covers no-heat and heat-will-not-shut-off symptoms, with different electric and gas component lists. Thermistors, high-limit protection and thermal cut-off checks appear alongside the heater circuit tests. The fault table also identifies restricted airflow. Use the complete sheet and correct wiring information rather than treating a fault code as a confirmed failed part.
W10806847B is the document recovered from this model page. Exact WED92HEFW0 revision applicability is still under review. Confirm the document number, control design and wiring against the appliance’s supplied tech sheet.
Document references
W10806847B is a 60-page technician tech sheet, distinct from an owner use-and-care guide. Confirm the sheet number against the appliance, and use Whirlpool’s lookup below when seeking owner instructions.
For owner instructions, use Whirlpool’s manual lookup with the complete model from the appliance label.